The Construction Of Cultural Stone Is Different From Ordinary Wall Construction

The construction of cultural stone is very different from ordinary wall construction.

1. Clean the wall surface and make a rough surface. If it is a smooth surface with low water absorption such as plastic wood, it must be covered with barbed wire and a rough bottom surface, and then paved after adequate maintenance.

2. Before pasting the rocks, be sure to arrange the rocks on the flat ground to get the best effect, and then lay them in the order of arrangement. Rocks of similar size, shape, and color should not be adjacent to each other.

3. White cement above No. 425, ordinary cement (the ratio of cement: sand: 801 glue is 1:2:0.05), ceramic adhesive (please pay attention to the instruction of adhesive) high-performance special adhesive can be used as glue.

4. Wet the rock fully, and apply the adhesive in the center of the bottom of the rock to form a mountain shape (a thin layer of adhesive can be applied to the bottom of the brick when pasting antique bricks). If the surface is accidentally dirty in a large area, use a brush in time Use after washing.

5. Paste the corner first. Press fully so that the adhesive can be seen extruding around the rock (some products do not need corners).

6. If the construction needs, the rock can be cut to adjust.

7. Use plastic bags to fill the paint to fill the gaps, pay attention to grasp the depth, the deeper the gap, the better the three-dimensional effect of the product.

8. After the initial setting of the caulking agent, remove the excess caulking material with bamboo chips, etc., and repair the surface of the gap with a brush soaked in water. If there is a small amount of caulking agent or adhesive on the surface of the rock accidentally, wait for it to dry Afterwards, remove with a brush. better. Some products do not require seams.

9. When the rock is used outdoors, after paving and pasting, the product and caulking agent can be sprayed with protective agent for protective treatment after the product and caulking agent are completely dry (waterproof, antifreeze, anti-ultraviolet, anti-alkali, etc.).

10. Requirements for seams to be dealt with (1) Random-shaped rocks—the smallest seam circumference is about 10mm, and the difference in size of random shapes can be adjusted with a caulking agent.